Key Takeaways
- Grinding or straining of your opener motor can mean bigger problems for your garage door system.
- A Wayne Dalton Torquemaster spring replacement is often misdiagnosed as an opener problem. The symptoms of a failing Torquemaster spring and an opener problem are similar. Both problems appear to be a problem opening the door. Both problems allow for varying amounts of effort to complete the cycle.
- Booking the repair of your Wayne Dalton Garage Door for an unusual noise could save you hundreds of dollars versus replacing the garage door opener motor that has burned up.
Introduction
A Garage Door Opener is one of the hardest-working items in your home, operating daily and generally giving you some indication that something is amiss before it fails. A new sound, slower operation, or door reversing are typical indicators of potential problems with your garage door opener.
Addressing these early indicators of potential problems with your garage door opener should be a relatively fast and inexpensive repair by Wayne Dalton Garage Door Service. Waiting too long could result in the more serious problems of a motor failure, a door that becomes “stuck,” or worse, an expensive emergency repair on a Saturday night.
What’s the First Sign an Opener Is Starting to Fail?
Listen before you look. A good opener runs with a background hum, and if that changes (grinding, clicking, or delaying starting), then something’s not right – either inside. Electric motors rarely fail without warning. They usually begin showing signs of wear, such as unusual noises or slower operation, weeks before they stop working.
Why Does the Door Reverse or Stop Partway?
It’s nearly always a safety sensor or force-setting problem, and it’s one of the busiest calls we receive here throughout Arizona. The two photo-eye sensors right at the bottom of the track need to be in precise alignment, and even a gentle nudge from a parked bike can upset them.
Clean the two lenses; make sure both of the sensor lights are solid instead of flashing, and remove obstructing objects from the path of the beam. Still reversing after that? The opener’s strength settings may require professional calibration.
Could a Slow or Heavy Door Actually Be a Spring Problem, Not the Opener?
This is one of the most common causes of misdiagnosis we see. Homeowners naturally just think the opener is dying, but in reality it might be just a worn spring that has added weight to the door and exceeds what the motor was designed to lift. With TorqueMaster springs, like those on Wayne Dalton doors in particular, the spring wears out from the inside, making it difficult to detect damage during a visual inspection.
Replacing a Wayne Dalton Torquemaster spring restores balance, and when that occurs, the opener is not struggling to lift or lower it and often begins running quieter immediately. Do a quick spring check if your opener sounds like it’s struggling to lift the door; the motor may be at fault, but first check the spring.
What Do Grinding or Clicking Noises Usually Mean?
Grinding noises indicate worn gears inside the drive unit. If you click but don’t move, that usually means the drive gear has stripped and is just free spinning without engaging the chain/belt at all. Continuing to operate the opener while it grinds can cause significantly more damage and lead to costly repairs.
Why Does My Remote or Keypad Suddenly Stop Working?
Don’t assume that the opener itself is defective; check simple stuff first: a dead remote battery, a remote that has fallen out of sync, keypad programming erased during a power failure, or an antenna that’s broken. If none of these do, it is very likely that the receiver board inside the opener needs replacing too but this would be a repair rather than an entire unit replacement.
How Does Arizona’s Climate Speed Up Opener Wear?
Garage door lubricant is known to deteriorate under extreme temperatures. In warmer temperatures, the lubricant will become softer and can get into the gears and belts of the garage door. In colder temperatures, the lubricant is unable to lubricate the plastic parts of the garage door, and they can become brittle. It is recommended to have your garage door serviced by Wayne Dalton on a yearly basis and ideally two times a year to prevent any future problems.
When Is It Time to Replace the Opener Instead of Repairing It?
A garage door opener is a piece of machinery. It can and will wear out. After 10 years, a garage door opener may begin to fail, especially if it does not have rolling-code security. And, honestly, if you have to repair it 3 times in the last 2 years, it is time to replace the entire system. Many garage door openers these days come with a battery back-up, and can be operated from your smartphone.
Hear That Grinding Noise? Act Before the Door Decides To Stop Turning
Elite Garage Doors & Gates has been servicing garage doors and openers in Arizona since 2000, with around-the-clock response to emergency requests. We’re also a state-certified Wayne Dalton dealer.
Claim Your Opener Inspection →
The Bottom Line
Emergency garage door repair problems will alert you to their failure several weeks before they finally stop working completely. Listen for new noises that your garage door opener makes, watch for slower operation of your garage door, and check your garage door for being unbalanced.
If you determine any of these problems, it is highly recommended that you allow Elite to provide the repair work before there is a high probability that additional repairs will be needed within a short time period, and by fixing it all at one time, you can avoid the added expense of an entirely new garage door opener in the near future.
If you have a garage door that seems to require an inordinate amount of effort to open, then Wayne Dalton Torquemaster spring replacement could be an option for you.
